INTRODUCTION:

AMD series High Voltage Power Amplifiers, High Voltage Amplifiers, Wisman High Voltage Power Supplies are launched for various industrial and research applications such as piezoelectric drive and control, laser modulation, semiconductor research, etc. All solid-state high voltage insulation design for high slew rate, wide bandwidth and low noise operation. Four-quadrant active outputs sink or source current into reactive or resistive loads over the entire output voltage range. This type of output is critical for accurate output response and the high slew rates required for various loads such as highly capacitive or reactive loads. The high-voltage amplifier launched by Wisman High Voltage Power Supply is a non-inverting amplifier.

Bipolar: AMD0.7R70

Unipolar: AMD1.4P70

Unipolar: AMD1.4N70

FEATURES:

Four-quadrant output, used to drive capacitive loads
Closed loop system for high accuracy
Short circuit protection for equipment protection
All solid state design, maintenance-free operation
DC stable programmable power supply application
Low output noise, providing ultra-precise output

APPLICATION:

elastomers,Dielectric  soft robots, HASEL actuators (artificial muscles), electroactive polymers (EAP), ionically conductive polymer gel films (ICPF), artificial musclespneumatic  (PAM), electroviscous fluids (ER fluids), Magnetorheological Fluids (MR Fluids), Ferroelectric Testers, Piezoelectric Actuation and Control, Laser Modulation, Semiconductor Research, Electrostatic Deflection, Electrorheological Fluids, AC or DC Bias, Particle Accelerators, Mass Spectrometers, Materials Characterization, Ferroelectricity Bulk, atmospheric plasma, dielectric barrier discharge, dielectric barrier discharge (DBD), DBD plasma actuator, atmospheric pressure plasma, corona discharge, electrostatic levitation furnace (ELF), electrostatic tactile display, water tree, dielectric shock Penetration testing, ion beam deflection, electron beam deflection, electrophoresis, dielectrophoresis (DEP), flash sintering, material polarization, ion engines, particle accelerators, material characterization, electrostatic actuators, electrospinning, electrostatic spraying, electrostatic coating packaging, solar panel (photovoltaic) testing, Langmuir probes, electro-optic modulation, electrophotography, corona generators, Scorotron grid consumables, primary charging rollers (PCR), developing rollers, corona charging supplies, photosensitive drums Charging, electrostatic chucks, electrostatic deflection of charged particle beams, 3D printing (application of electrohydraulic dynamics (EHD) technology), etc.

SPECIFICATION:

Input voltage: 220AC±10%

Input current: 3A

Output voltage: 0 ~±700V DC or AC peak

Output current: bipolar 0 ~ ± 100 mA DC or AC peak; unipolar 0 ~ ± 50 mA DC or AC peak

Input voltage range: 0 to ±10 V DC or peak AC

Input impedance: non-inverting 90kΩ, inverting 1MΩ

DC voltage gain: 200V/V

DC voltage gain accuracy: better than 0.1% of full scale

DC offset voltage: less than ±500mV

Output noise: less than 100mV rms

Slew rate: Bipolar greater than 380 V/μs (typically 10% to 90%), unipolar greater than 370 V/μs (typically 10% to 90%)

Large Signal Bandwidth

Bipolar: DC to greater than 125khz (-3 db); Unipolar: DC to greater than 120khz (-3 db)

Small signal bandwidth (-3 db): DC to greater than 200khz

Stability: less than 50ppm /hr, non-cumulative

Temperature Coefficient: Less than 25ppm/°C

Operating Temperature: Temp 0°C to 40°C (32°F to 104°F)

Working humidity: 85% relative humidity, non-condensing

Maximum altitude: 2000 meters (6561.68 feet) above sea level

Dimensions: 44mm H x 483 mm W 483 mm D (1.73H x 19”W x19”D)

Weight: 15kg

Voltage display

Display ratio: 200:1

DC accuracy better than 0.1% of full scale

DC offset voltage less than ±2 mV

Output noise is less than 10mv root mean square

Output impedance 47Ω

Current display

Display scale: 0.1 V /1mA

DC accuracy greater than 0.5% of full scale

Offset voltage less than ±10 mV

Output noise is less than 30mv

Output impedance 47Ω

TREK PZD700A

For information concerning our high voltage products, please call at 086-029-33693480 or visit our website https://www.wsmhv.com

Wisman advances medical care, industrial processes, quality control, scientific research, security and telecommunications by providing innovative high voltage power supplies including micro-modules high voltage power supply, modules high voltage power supply, X-ray generator, rack mount voltage power supply, special customized high voltage power supply, high voltage accessories, etc. that enable equipment manufacturers to improve their systems’ performance, reliability, cost and bottom line. Power range from 100mW to 200kW, voltage range from 60V to 500kV. You can purchase multiple varieties and specifications in one-stop from us. We have a high-voltage power supply research and development team, high-voltage power supply development software and software for testing high voltage insulation technology and zero current resonance technology, making our high voltage power supplies maintain high stability, low ripple, excellent in EMC. Our products are compact, highly efficient with a long operating life.

Wisman high voltage power supplies are competitively priced and a great idea for OEM customers.